Starting my 4x8 frame build, couple questions

jeepsr4ever

Hard to say with the plasma cutter now giving an audible issue. A small air leak can sometimes sound like a crackle.

f_armer

jeepsr4ever;133787 wrote
Hard to say with the plasma cutter now giving an audible issue. A small air leak can sometimes sound like a crackle.

It's not air, I never had the air hooked up.
Ill try and see if I can borrow my friends pm45 one of these days, and see if the voltage acts the same.

f_armer

Tom wants me to rma the pwm. He thinks that's the reason my voltage is acting up. So I'll give that a try.

f_armer

I got my new (used) dell gx620 pc. Have it optimized and ready to go. Cant cut with it until I get my pwm from candcnc though. I will keep you updated

f_armer

Finally got the new pwm in the mail. Everything seems to be working right. This is the first time I've been able to use thc. Happy happy happy.

jeepsr4ever

GREAT!

f_armer

Built a computer desk and a water tank for draining the table. Tank is 18" tall x 24" wide 48" long. Holds 87 gal. Works well. I have two 1-1/2" drains in the table that tee into a 2" strainer, and 2" plumbing to the tank. It takes very little air pressure to fill the table back up. [ATTACH=CONFIG]398[/ATTACH] [ATTACH=CONFIG]399[/ATTACH]

f_armer

Built the tank using the table. Cut slits for bending and for welding the inner supports for the top. Worked good, but it obviously does add a bit more welding than using a brake. [ATTACH=CONFIG]400[/ATTACH] [ATTACH=CONFIG]401[/ATTACH] [ATTACH=CONFIG]402[/ATTACH]

« Previous Page