401 wanted

86cj7

wanted a running 401 that is reasonably priced. i am located in weymouth ma

PavementPounder

I have this one if you don't find any other options:

http://www.bulltear.com/forums/viewtopic.php?t=9352

I have family in NE New Jersey and could perhaps work transportation to that point into a trip home.

86cj7

too bad you don't want a chevy dana60 front i have one that i am selling along with a ford dana60 rear

PavementPounder

86cj7 wrote
too bad you don't want a chevy dana60 front i have one that i am selling along with a ford dana60 rear

The Chevy fronts are still very useful to wheelers in SRW form, but lesser in value than the HP. If the front is SRW and the set is complete, I can fish it around and see if anyone out here would be interested.

86cj7

it is a srw with warn hubs ,an extra set of outer stub shafts and a set of stock hubs as well 4:10 gears the rear is a 1976 f250 ford hd dana60 4:10's full float (this rear end has alot of extra webbing around the pumpkin)

PavementPounder

Okay. If you have the time to pull a shaft, I'd appreciate verification of that rear axle's spline count. Are you on any other boards where I can PM you? IFSJA? Pirate?

86cj7

pirate 86cj7rjs

PavementPounder

86cj7 wrote
pirate 86cj7rjs

I'll hit you up over there with contact info tonight. :t: I'm P@vementPounder there. (Someone beat me to it.)

JERSEYJOE

hey Mark: I have a matched set of axles from a 1 tom GMC. consists of a dana 60 front and a 14 bolt Full Floater rear with factory 4.56 and factory lockers. I also have the glove box door with the build sheet that describes the axles as I have

JERSEYJOE

mark I have a matched set of axles froma GMC 1 ton. Consists of a Dana 60 front and a 14 bolt full floater rear with factory 4.56's and factory lockers. I have the glove box door from the truck with the build sheet that describes the axles as I just have.

86cj7

JERSEYJOE wrote
mark I have a matched set of axles froma GMC 1 ton. Consists of a Dana 60 front and a 14 bolt full floater rear with factory 4.56's and factory lockers. I have the glove box door from the truck with the build sheet that describes the axles as I just have.

i guess they have different forum rules in jersey but here in ma i wouldn't try and sell/hijack something in someone else's thread
:t:

JERSEYJOE

Not hijacking. I know Mark a long time. Good luck with your sale.