360 Bored .030

Used Gum

What is the displacement of an AMC 360 after a .030 bore? Thanks in advance.

1980_Cj7

365 CI

Used Gum

Thank you sir.

1980_Cj7

You are welcome. And please don't call me Sir, I was an NCO and worked for a living, ha, ha. I was respected for what I did, not the rank on my uniform.

rollen dean montoya

i did too. but i put up with it . 365 sounds right . should give you some more ponies and grunt

dan58

1980_Cj7 wrote
You are welcome. And please don't call me Sir, I was an NCO and worked for a living, ha, ha. I was respected for what I did, not the rank on my uniform.

Thread hijack....

I find it's funny you say that. I work with the military all the time, and I'm accustomed to saying Sir and Ma'am. People in the general public look at me like I have three heads when I say that.

Used Gum

I'm a SFC stationed at Fort Drum in New York hitting 16 years next month if that explains anything. 111!!! I, as much as anyone, appreciate veterans. :sa: Does anyone know the weight difference between stock and Edelbrock cylinder heads??? Trying to figure out the additional weight loss (gain) going aluminum among the others obvious reasons.

ironman_gq

Aluminum is about 1/3 the weight of cast iron so the edelbrock heads probably weigh less than half what the stock ones do.

Used Gum

Do you have an actual number (lb/kg) by any chance? Or I just could steal my wifes bathroom scale, but I just had back surgery?!

jeepsr4ever

Edelbrock heads are exaclty half of the iron heads