Lifted79CJ7
Think I should part it out or sell it whole? Probably parting it outwould be better since it is still in pieces...
1977 CJ7
-Body stinks and is dented and rusty
-Good frame with repairs already made - includes MORE rear frame plates installed already
-Outbaorded front springs
-Scout 44's
--front pumpkin turned to t case and 5 degrees caster added
--front brakes have less than 3K miles
--new rear drum brake pistons
--stainless brake lines front and rear, new hard lines on rear axle
-Spring Over
-Rubicon Express leaves
-Sway bar disconnects
-Doetsch Tech Shocks
-Steering box stabilizer
-Hardtop and Sunrider softtop
-2 sets hard doors, one fair condition with light tint, one rusty and dented
-New hood
-New tailgate
-94 Roll bar with front CJ hoop kit for dash pad
-Cobra CB
-new oil and volt guages
-Steelhorse center console black
-new tailgate metal ropes
-new rear TJ flairs
-excellent condition grill with hood lock to replace rust pitted one
-wiring harness from my previous CJ with a Alpine alarm with motion sensor already installed
-lots of relays and cool switches for different lights
-winshield hinge light mounts
-one broken windshield but dented frame and barely used gasket
-LED third brake light on hard top wired up with disconnect wires
-hardtop light wired to alarm with disconnect
-lowback ripped seats
-good seat frames
-Dissasembled AMC 401
--new Edle performer cam
-- " " " 600 cfm carb with offroad needles and seats kit installed
-- " " " timing chain
-- " " " 14" chrome air cleaner with spacer
-- " " " intake - non egr
--bulltear oil filter reloation kit
--bultear inspected timing chain cover and gears
--no valves, rocker arms - threw away
--new stock pushrods
--bulltear cam and distributor gears
--engine is bare - does not appear to have been bored yet, but have not been to machine shop yet to verify (stock pistons)
--msd off road ignition with optional rev limiter
--stock ignition system with new spare motorcraft module
--stock rods and crank
--block has had the inside pressure washed out
--not installed oil valley kit
--new felpro gasket kit
--used 401 flywheel - bought it then went to automatic
--new 401 to 727 flywheel
-Grandwaggy 727 - condition unknown
--locar kick down cable
--B&M Mega shifter - a little dryrotted on the boot
--Bulltear shifter handle (might have to keep this though!) - says "401"
-dana 300 - stock
-shortened front driveshaft to put on rear to be able to keep in park - new u joints but CV's would be the way to go here. No front driveshaft
-still in box poly body mount kit
-new rear corner repair panels
-Swing out tire mount, modified to raise it a couple of inches for larger tires
-alpine tape deck and 6 disc changer
-kenwood 2 channel sub amp - new
-alpine amp - 40 x 2
-mtx crossover
-phoenix gold distribution block and fuse block
-custom front bumper with fog lights
-dual 2.5 inch flowmaster exhasuet with stock exhaust manifolds
Shoo, there are probably tons more stuff that I can't think of.
Anyone interested in it as a whole?
:smile:
Jack
