360 tear down

79J-20

Do I need to keep the rocker arms, bridges, pivots and push rods together with the cylinder they came from? I know that marking the bottom end is a must. But what about the top end on a AMC? The heads have been apart before and some of the bridges have a slight "S" shape to them. Can they be bent back or should they be replaced? I plan on doing a rebuild close to what MrFuriuos is planning. So should I just replace rockers and pushrods anyway? Thanks

fuzz401

I would replace the bridge and rockers and the push rods just to be on the safe side

BREK

IF YOU PLAN ON REUSING THE OLD PARTS MAKE SURE TO PUT THEM BACK IN THE CYLINDER THEY CAME FROM BUT IT WOULD BE CHEAP INSURANCE TO JUST USE NEW PARTS. :mrgreen: