cobra5laddict
i am at the final stages of assembly on my 360. it is a 80-84 model.
the tappets i got with the rebuild kit are sealed power. the specs are:
height 1.85
width .903
my old lifters are:
height 1.895
width .91
does anyone have a TSM that can look up the factory tolerances for a 360? i have a 1979 TSM but it only covers the 304. it lists the width as: 9.04 - 9.06
the new tappets are sealed power PN ht 2011
any advice guys?
am i going to have a problem with these new lifters being a touch loose in the bore (compared to the orig) and a touch shorter?
thanks guys!
Lifted79CJ7
If this helps ya, the 304, 360, and 401 are all the same, just based on the fact that my Edelbrock cam/lifters can be fit into all of these engines.
jeepsr4ever
are you certain your old lifters are .910? Thats out of spec of any lifter....hmmm
cobra5laddict
i borrowed a friends digital calipers to check mine... yeah i must have dropped them one to many times... good news is the lifters are fine... bad news i need new digital calipers
jeepsr4ever
DOH :mrgreen:
